Fanuc Power Mate i-D/H Operation Maintenance Handbook

7. HARDWARE
183
7.5.8 Ethernet board
D Specification
Name
Specification
Ethernet board A20B–8100–0450
D Connector and LED locations
PAR LED B
COL LED A
LED 4
STA– LED 3
TUS LED 2
LED 1
TX LED 5
RX LED 6
Ethernet
connector
CD38L
Setting pin TM1
Connector for
connection with
the backpanel,
JNA
Red
Green
Red
NOTE Never change the setting of the setting pin TM1.
D Status indication
In the following explanation, the LED status is indicated as shown below:
j : Off J : On l : Blinking z : To be ignored
At power–up
NO.
LED 4 3 2 1
Description
1 STATUS jjjj Power off
2 STATUS JJJJ Initial status immediately after power–up
3 STATUS JJJj MPU initialization completed
4 STATUS JJjj Firmware downloading completed
5 STATUS Jjjj Control passed to the OS
6 STATUS jJJJ OS PHASE 1
7 STATUS jJJj OS PHASE 2
8 STATUS jJjJ OS PHASE 3
9 STATUS jJjj OS PHASE 4
10 STATUS jjjl Activation completed/Normal status

Leave a Reply

Your email address will not be published. Required fields are marked *