Fanuc Power Mate i-D/H Operation Maintenance Handbook

7. HARDWARE
207
Primary
ExplanationTertiary
and sub-
sequent
operation
Secondary
Confirmation of setting
Displaying selected data
D The item selected when 1 or 2 is selected as
the primary selection with the rotary switch is
displayed on the 7segment LED.
Returns to the secondary selec-
tion.
Displays the number selected as
the secondary selection when 1 is
set as the primary selection with
the rotary switch. When no value
is set, the 7segment LED is off.
Displays the device number set
for the CRT sharing function when
2 is selected as the primary selec-
tion with the rotary switch.
Memory all clear
D Clears all SRAM data in the memory module. The all clear
operation performed after memory module replacement must
be performed by following this method.
D After completing the primary selection, pressing the pushbut-
ton switch starts allclear processing.
D After processing starts, the indication on the 7segment LED
changes as follows:
(Low–speed blinking) :
All–clear processing in progress.
Executed after the pushbutton switch is
pressed.
(On) : Normal termination
(Blinking) : SRAM ECC Error
Copies SRAM data into the builtin FROM.
D The SRAM data backed up by battery is copied into the built
in FROM of the Power Mate. This is a data backup method
performed at printedcircuit board replacement not involving
fuse replacement or memory module mounting/dismounting.
D After completing the primary selection, pressing the pushbut-
ton switch starts processing.
D After processing starts, the indication on the 7segment LED
changes as follows:
(Low–speed blinking) :
Save operation in progress.
Executed after the pushbutton switch is
pressed.
(On) : Normal termination
(On) : An alarm is issued (such as ROM parity)

Leave a Reply

Your email address will not be published. Required fields are marked *