Fanuc Power Mate i-D/H Operation Maintenance Handbook

3
1
4
5
6
7
8
9
10
2
208
Primary
ExplanationTertiary
and sub-
sequent
operation
Secondary
Saves data in a memory card in a batch.
D The SRAM data backed up by battery, and the ladder program,
C executor user program, and macro executor user program
stored in the FROM are all saved in file form on a memory card
in a batch.
D If the write protect switch of the memory card is not released,
an alarm is generated.
(A memory card is formatted before it is used to save data. Be
very careful when using the memory card.)
D After completing the primary selection, pressing the pushbut-
ton switch starts processing.
D After processing starts, the indication on the 7segment LED
changes as follows:
(Low–speed blinking) :
Save operation in progress.
Executed after the pushbutton switch is
pressed.
(On) : Normal termination
(On) : An alarm is issued.
Abnormal memory card, memory card
with the write protect switch set to ON,
and so forth
(On) : A alarm is generated.
(Memory card full)
Restores SRAM data from the builtin FROM.
D SRAM data copied into the builtin FROM by selecting 7 as
the primary selection with the rotary switch is restored in the
SRAM.
D After completing the secondary selection, pressing the push-
button switch starts restoration.
D After restoration starts, the indication on the 7segment LED
changes as follows:
(Low–speed blinking) :
Restoration in progress.
Executed after the pushbutton switch is
pressed.
(On) : Normal termination
(On) : An alarm is generated.
When saved data is not found.
Restores SRAM data copied into the built–in
FROM
Reserved

Leave a Reply

Your email address will not be published. Required fields are marked *