Fanuc Power Mate i-D/H Operation Maintenance Handbook

3
1
4
5
6
7
8
9
10
2
224
Number RemarksContents
1251 Coordinate value of the reference position on
each axis used for setting a coordinate system
automatically when input is performed in inches
<Axis>
PRM
1201#1=1
1260 The amount of travel per rotation <Axis>
9) Parameters of Stored stroke check
Number
Contents Remarks
1300 Relating to Stroke check
#6 LZR : The stored stroke check are checked during
the time from power-on to manual return to the
reference position (0)/not checked (1)
#7 BFA : When a command that exceeds a stored
stroke check is issued, an alarm is generated
after the stroke check is exceeded (0)/before
the check is exceeded (1)
PRM1320,
1321
1320 Coordinate value I of stored stroke check 1 in
the positive direction on each axis
<Axis>
1321 Coordinate value I of stored stroke check 1 in
the negative direction on each axis
<Axis>
10) Parameter of Feedrate
Number
Contents Remarks
1401 Parameter relating to Feedrate
#0 RPD : Manual rapid traverse before the completion of
return to reference position is disable (0)/
enable (1)
#1 LRP : Positioning (G00) is nonlinear (0)/linear (1).
#4 RF0 : When cutting feedrate override is 0% during
rapid traverse, the machine tool does not stop
moving (0)/stops moving (1)
#5 TDR : Dry run during tapping in the canned cycle
(G74, G84) is enable (0)/disable (1)
#6 RDR : Dry run for rapid traverse command is, disable
(0)/enable (1)
Only for
PMi–D
1404 Reference position return
#1 DLF : After a reference position has been
established, a manual reference position return
operation is performed at the rapid traverse
rate (PRM1420) (0)/at the manual rapid
traverse rate (PRM1424) (1).
#2 F8A : With inch input, Valid data range for an F
command in feed per minute mode 9600
deg/min (0)/24000 deg/min (1)
1405 Speed changeover
#7 FDC : Enables (1) / disables (0) the speed
changeover function.

Leave a Reply

Your email address will not be published. Required fields are marked *