Fanuc Power Mate i-D/H Operation Maintenance Handbook

8. PARAMETERS
225
Number RemarksContents
1410 Dry run rate (feedrate of jog override is 100 %)
[mm/min]
1411 Cutting feedrate in the automatic mode at
power-on [mm/min]
1420 Rapid traverse rate for each axis
(Rapid traverse override is 100%) [mm/min]
<Axis>
1421 F0 rate of rapid traverse override for each axis
[mm/min]
<Axis>
1422 Maximum cutting feedrate for each axis
[mm/min]
<Axis>
PRM1430
1423 Manual continuous feedrate for each axis (jog
feedrate) [mm/min]
<Axis>
1424 Manual rapid traverse rate for each axis
If 0 is set, the rate set in PRM1420 is assumed
[mm/min]
<Axis>
PRM1420
1425 FL rate of return to the reference position for
each axis [mm/min]
<Axis>
1430 Maximum cutting feedrate for each axis
[mm/min]
<Axis>
PRM1422
1431 Maximum cutting feedrate for all axes in the
look-ahead feed forward mode [mm/min]
1432 Maximum cutting feedrate for each axis in the
look-ahead feed forward mode [mm/min]
<Axis>
PRM 1431
1480 Lower limit of feedrate for the rate feed function
1481 Feedrate for speed switching signal EXF1
1482 Feedrate for speed switching signal EXF2
1483 Feedrate for speed switching signal EXF3
1484 Feedrate for speed switching signal EXF4
1485 Feedrate for speed switching signal EXF5

Leave a Reply

Your email address will not be published. Required fields are marked *