Fanuc Power Mate i-D/H Operation Maintenance Handbook

8. PARAMETERS
227
Number RemarksContents
1620 Time constant of linear acceleration/
deceleration in rapid traverse for each axis
bell–shaped acceleration/deceleration in rapid
traverse for each axis [msec]
<Axis>
1621 Time constant T2 used in bell-shaped
acceleration/deceleration in rapid traverse for
each axis [msec]
<Axis>
1622 Time constant of exponential function
acceleration/deceleration in cutting feed for
each axis [msec]
<Axis>
1623 FL rate of exponential function acceleration/
deceleration in cutting feed for each axis
[mm/min]
<Axis>
1624 Time constant of exponential function
acceleration/deceleration in manual continuous
feed for each axis [msec]
<Axis>
1625 FL rate of exponential function acceleration/
deceleration in manual continuous feed for
each axis [mm/min]
<Axis>
1630 Maximum machining speed during linear
acceleration/deceleration before interpolation
[mm/min]
In
look-ahead
feed
forward
1631 Time until the machining speed reaches the
maximum speed during acceleration/
deceleration before interpolation [msec]
forward
mode,
PRM1770,
1771 are
enabled.
1635 Time constant for cutting feed acceleration/
deceleration or time constant T
1
post–interpolation bellshaped acceleration/
deceleration related to cutting feed for an
individual axis in the highspeed response
mode
PMi–H
1636 Time constant T for rapid traverse linear
acceleration/ deceleration or T
1
for rapid
traverse bellshaped acceleration/deceleration
for an individual axis in the high–speed
response mode
PMi–H
1637 Time constant T
2
for rapid traverse
bell–shaped acceleration/deceleration for an
individual axis in the highspeed response
mode
PMi–H
1638 Time constant T
2
for post–interpolation
bell–shaped acceleration/deceleration related
to cutting feed for an individual axis in the
high–speed response mode
PMi–H
1722 Rapid traverse deceleration ratio when blocks
in rapid traverse are overlapped [%]
<Axis>
PRM
1601#4

Leave a Reply

Your email address will not be published. Required fields are marked *