Fanuc Power Mate i-D/H Operation Maintenance Handbook

3
1
4
5
6
7
8
9
10
2
234
Number RemarksContents
1932 Connector number for the second pulse module
(dedicated to the FSSB setting screen)
<Axis>
1934 Master and slave axis numbers subject to
tandem control (dedicated to the FSSB setting
screen)
<Axis>
1936 Connector number of the first pulse module <Axis>
1937 Connector number of the second pulse module <Axis>
1960 Start address of an R area to which the DI bit
information of the FSSB I/O module for the first
group is transferred
1961 Size of an R area to which the DI bit
information of the FSSB I/O module for the first
group is transferred
1962 Start address of an R area where the bit
information to be output to the DO of the FSSB
I/O module for the first group is stored
1963 Size of an R area where the bit information to
be output to the DO of the FSSB I/O module for
the first group is stored
1964 Start address of an R area to which the DI bit
information of the FSSB I/O module for the
second group is transferred
1965 Size of an R area to which the DI bit
information of the FSSB I/O module for the
second group is transferred
1966 Start address of an R area where the bit
information to be output to the DO of the FSSB
I/O module for the second group is stored
1967 Size of an R area where the bit information to
be output to the DO of the FSSB I/O module for
the second group is stored
1968 Address of an R area where the status
information about DO alarms is output
2000 Parameter for servo <Axis>
#0 PLC0 : 0.1 mm control is, not performed (0)/
performed (1)
#1 DGPR : When the power is turned on, the digital
servo parameter specific to the motor is set
(0)/not set (1).
#3 PRMC :
#4 PGEX : Position gain range is not expanded (0)/
expanded by 8 times (1)
PRM2023,
2024, 1836
Unusable

Leave a Reply

Your email address will not be published. Required fields are marked *