Fanuc Power Mate i-D/H Operation Maintenance Handbook

1. SCREEN DISPLAY AND OPERATION
7
1.2.2 Displaying the current position
(1) Displaying the position using absolute coordinates
(a) Press soft key [ABS].
ABS
[][][][][]
REL ALL HNDL OPRT
ACTUAL POSITION (RELATIVE) O1000 N00010
Program number
Sequence
number
X 123.456
Y 363.233
Z 0.000
PART COUNT 5
RUN TIME 0H15M CYCLE TIME 0H 0M38S
ACT.F 3000 MM/M S 0 T0000
AUTO STRT MTN*** 09:06:35
Parameter
(No.6711)
Time from
when the OP
signal is
turned off
(One machin-
ing cycle)
Parameter DPS
(bit 2 of No.3105)=1
Inches/min is used when
values are input in inches.
Parameter DPF
(bit 0 of No.3105)=1
Displaying the number of parts and the operation time
(b) Operation
Soft key [(OPRT)] [PTSPRE] [EXEC]
[RUNPRE] [EXEC]
(c) Related parameters
Parameter NDP (bit 0 of No.3115) : 0: The current position is
displayed for each axis.
1: The current position is not
displayed for each axis.
Parameter PCM (bit 0 of No.6700) : The total number of machined
parts and the number of
machined parts are
incremented when the
following M codes are
specified.
0: M02, M03, and the M codes
specified with parameter No.
6710
1: The M codes specified with
parameter No. 6710
Parameter NCT (bit 7 of No. 6700) : The operation time and the
number of parts are:
0: Displayed.
1: Not displayed.
Parameter No. 6710: M code that counts the total number of
machined parts and the number of machined
parts in the current operation
Parameter No. 6711: Number of machined parts
Parameter No. 6751: Operation time (integrated time value during
automatic operation) [ms]
Parameter No. 6752: Operation time (integrated time value during
automatic operation) [min]
NOTE Hours and minutes are displayed on
the screen.
Parameter No. 6757: Operation time (integrated value in one
automatic operation) [ms]

Leave a Reply

Your email address will not be published. Required fields are marked *