Fanuc Power Mate i-D/H Operation Maintenance Handbook

3
1
4
5
6
7
8
9
10
2
250
Number RemarksContents
3216 Increment in sequence numbers inserted
automatically
PRM
0000#5=1
3230 Program registration
#6 O48 : Program numbers have four digits (0)/eight
digits (1).
3290 Parameter for protect of data input
#2 MCV : Macro variable setting by MDI key input is not
disabled (0)/disabled (1)
#6 MCM: Macro variable input from the MDI panel is
enabled regardless of which mode is set (0)/
enabled in MDI mode only.
#7 KEY : The KEY1 to KEY4 signals are used (0)/KEY1
is used for program protection (1).
3291 Memory protection
#0 WPT : The input of the tool offset amount is enabled
according to signal KEY1 (0)/enabled
regardless (1)
15) Parameters for programs
Number
Contents Remarks
3401 Parameter for G code
#0 DPI : When a decimal point is omitted in an address,
the least input increment is assumed (0)/the
unit of mm, inches, or sec. is assumed (1)
#4 MAB : When in the MDI operation, switching between
the absolute and incremental commands is
performed by G90 or G91 (0)/depending on the
ABS setting in parameter 3401#5 (1)
#5 ABS : When in the MDI operation, program command
is assumed as an incremental command (0)/
absolute command (1)
Calculation
type
PRM
3401#4=1
3402 Parameter for G code
#0 G01 : When the power is turned, the mode is G00
(0)/G01 (1)
#1 G18 : When the power is turned, the mode is
G17/G18/G19
#2 G19 : When the power is turned, the mode is
G17/G18/G19
#3 G91 : When the power is turned, the mode is G90
(0)/G91 (1)
#6 CLR : Cause reset state the CNC with Reset
signal(0)/cause clear state (1)
0
G19 G18 G17, G18, or G19 mode
0 G17 mode (plane XY)
0 1 G18 mode (plane ZX)
1 0 G19 mode (plane YZ)

Leave a Reply

Your email address will not be published. Required fields are marked *