Fanuc Power Mate i-D/H Operation Maintenance Handbook

8. PARAMETERS
253
Number RemarksContents
3705 Parameter for gear shift of spindle PMi–D
#0 ESF : The SF signal output condition is such that S
codes and SF are output with all S commands
(0)/not output when constant surface speed
control is used or the spindle speed is clamped
(1).
#1 GST : The SOR signal is used for spindle orientation
(0)/gear shift (1)
#2 SGB : The gear switching method is method A
(PRM3741, 3743) (0)/ method B (PRM3751,
3752)(1)
#3 SGT : The gear switching method during G84 and
G74 is method A (0)/method B (1)
#5 NSF : When an S code command is issued in
constant surface-speed control, SF is output
(0)/not output (1)
#6 SFA : The SF signal is output when gears are
switched (0)/irrespective of whether gears are
switched (1)
PRM
3705#5
PRM3751,
3752
PRM3761,
3762
3706 Parameter for the voltage polarity of spindle PMi–D
#0 PG1 : The gear ratio of spindle to position coder
( 1, 2, 4, 8)
#1 PG2 : The gear ratio of spindle to position coder
( 1, 2, 4, 8)
#4 GTT : Spindle gear selection is based on M type (0)/
T type (1).
#5 ORM : The voltage polarity during spindle orientation
is positive (0)/negative (1)
#6 CWM : The voltage polarity when the spindle speed
voltage is output
#7 TCW : The voltage polarity when the spindle speed
voltage is output
1
2
4
8
PG2
0
0
1
1
0
0
1
1
TCW CWM Volt. polarity
0
1
0
1
M03, M04 = +
M03, M04 =
M03 = +, M04 =
M03 = , M04 = +
PG1
0
1
0
1
SLPCA
signal
SLPCB
signal
PRM
3705#0
3708 Parameter for spindle speed arrival signal PMi–D
#0 SAR : The spindle speed arrival signal is not checked
(0)/checked (1)
SAR signal
3715 Confirmation of the spindle speed signal PMi–D
#0 NSAx : This parameter specifies an axis for which
confirmation of the spindle speed reached
signal (SAR) is necessary (0)/unnecessary
(1)
3730 Dta used for adjusting the gain of the analog
output of spindle speed [0.1%]
PMi–D
3731 Compensation value for the offset voltage of
the analog output of the spindle speed
PMi–D

Leave a Reply

Your email address will not be published. Required fields are marked *