Fanuc Power Mate i-D/H Operation Maintenance Handbook

3
1
4
5
6
7
8
9
10
2
258
Number RemarksContents
4011 Number of speed detector pulses
#0 VDT1 : Speed detector setting (Following table)
#1 VDT2 : Speed detector setting (Following table)
#2 VDT3 : Speed detector setting (Following table)
#3 POLE1: The number of motor poles is 2 (0)/4 (1).
#4 MXPW: Setting of maximum power during
acceleration/deceleration (for each model)
#5 ADJG : Acceleration/deceleration status
determination condition (for each model)
#7 POLE2: The number of motor poles is set by bit 3 (0)/
is 8 (1).
0
0
0
0
1
1
VDT3
64 λ/rev
128 λ/rev
256 λ/rev
512 λ/rev
192 λ/rev
384 λ/rev
Number of pulse
0
0
1
1
0
0
VDT2
0
1
0
1
0
1
VDT1
4012 PWM setting
#0 PWM1 :
#1 PWM2 :
PWM setting (Set 00 usually.)
}
4013 Data of the dead zone of current
#0 ESEC : The position coder one-rotation signal is
detected on either edge (0)/on the rising
edge at all times (1).
#2 DS1 :
#3 DS2 :
#4 DS3 :
#5 DS4 :
#6 DS5 :
#7 PWM3K: Setting of a PWM carrier wave in the
output switching low-speed characteristics
area (for each model)
The data of the dead zone of current
(Set automatically)
4014 Spindle switching, MCC confirmation
#0 AXISSL : The spindle switching function is disabled
(0)/enabled (1).
#1 AXSUB : During sub-spindle rotation, the spindle
switching function is disabled (0)/enabled
(1).
#2 AXSLCT : The spindle switching (between the main
spindle and sub-spindle) MCC contact
check function is disabled (0)/enabled (1).
#3 CHGCLT: Output switching (between high speed and
low speed) is checked using the RCH
signal (0)/the MCC contact signal (1).
#5 SLVEN : The slave operation function is disabled
(0)/enabled (1).

Leave a Reply

Your email address will not be published. Required fields are marked *