Fanuc Power Mate i-D/H Operation Maintenance Handbook

3
1
4
5
6
7
8
9
10
2
264
Number RemarksContents
4159 Secondary current factor during rigit tapping
4160 Hysteresis of the speed detection level
4161 Constsnt for compensating for the phase of the
electromotive for at deceleration
4164 Conversion constant of phase V current
4165 Time constant of voltage filter for eletromotive
force compensation
4166 Regenerative power limit
4167 Reserved
4168 Overload current alarm detection level
(for low speed characteristic)
4169 Overload current alarm detection time constant
4170 Overload current alarm detection level
(for high speed characteristic)
4171 Arbitrary gear data between spindle and
Position coder
(HIGH no. of teeth on the spindle)
4172 Arbitrary gear data between spindle and
position coder (HIGH no. of teeth on PC)
4173 Arbitrary gear data between spindle and
position coder (LOW no. of teeth on spindle)
4174 Arbitrary gear data between spindle and
position coder (LOW no. of teeth on PC)
4175 Delay timer at ON of electromagnetic contactor
in unit (S series)
Spindle analog override zero level (α series)
[Parameters for spindle switching function is used (Sub–spindle)]
Number Contents Remarks
4176
to
4190
Bit parameter
4191 Bit parameter (User can not set)
4192
to
4194
Bit parameter
4195 Bit parameter (Automatic setting by parameter)
4196 Maximum motor speed
4197 Reached speed level
4198 Speed detection level
4199 Speed zero detection level

Leave a Reply

Your email address will not be published. Required fields are marked *