Fanuc Power Mate i-D/H Operation Maintenance Handbook

3
1
4
5
6
7
8
9
10
2
266
Number RemarksContents
4230 MS signal gain adjustment
4231 Regenerative power limit
4232 Delay time up to motor power shut–off
4233 Acceleration/deceleration time setting
4234 Spindle load monitor observer gain 1
4235 Spindle load monitor observer gain 2
4236 Motor voltage during normal rotation
4237 Motor voltage during orientation
4238 Motor voltage in the servo mode
4239 Position gain change ratio when returning to
the origin in the servo mode
4242 Reserved
4243 Arbitrary gear data between spindle and
position coder
(SUB/HIGH no. of teeth on spindle)
4244 Arbitrary gear data between spindle and
position coder (SUB/HIGH no. of teeth on PC)
4245 Arbitrary gear data between spindle and
position coder
(SUB/LOW no. of teeth on spindle)
4246 Arbitrary gear data between spindle and
position coder (SUB/LOW no. of teeth on PC)
4247 Spindle load monitor magnetic flux
compensation time constant (for high–speed
characteristic on the MAIN side)
4248 Spindle load motor torque constant (for
high–speed characteristic on the MAIN side)
4249 Spindle load monitor observer gain 1
(on the MAIN side)
4250 Spindle load monitor observer gain 2
(on the MAIN side)
4251 Spindle load monitor magnetic flux
compensation time constant (for low–speed
characteristic on the MAIN side)
4252 Spindle load monitor magnetic flux
compensation time constant
(for highspeed characteristic)
4253 Spindle load monitor magnetic flux
compensation time constant
(for lowspeed characteristic)
4254 Slip correction gain
(for highspeed characteristic)

Leave a Reply

Your email address will not be published. Required fields are marked *