Fanuc Power Mate i-D/H Operation Maintenance Handbook

3
1
4
5
6
7
8
9
10
2
268
Number RemarksContents
4282 Spindle load monitor torque constant
(for highspeed characteristic)
4283 Spindle load monitor torque constant
(for lowspeed characteristic)
[If the spindle switching function is provided: If the output switching function
is also used on the SUBspindle side]
Number Contents Remarks
4284 Motor voltage during normal rotation
4285 Motor voltage in the servo mode
4286 Base speed of the motor output specifications
4287 Limit value for the motor output specifications
4288 Base speed
4289 Magnetic flux weakening start velocity
4290 Current loop proportional gain during normal
operation
4291 Current loop integral gain during normal
operation
4292 Zero point of current loop integral gain
4293 Velocity factor of current loop proportional gain
4294 Current conversion constant
4295 Secondary current factor for excitation current
4296 Current expectation constant
4297 Slip constant
4298 Compensation constant for highspeed rotation
slip
4299 Compensation constant for voltage applied to
motor in the dead zone
4300 Electromotive force compensation constant
4301 Phase compensation constant for
electromotive force
4302 Compensation velocity factor for electromotive
force
4303 Time constant for changing the torque
4304 Maximum output zero point
4305 Secondary current factor in rigid tapping
4306 Constant for compensating for the phase of the
electromotive force at deceleration
4307 Limit of regenerative power
4308 Time constant of voltage filter for electromotive
voltage compensation

Leave a Reply

Your email address will not be published. Required fields are marked *