Fanuc Power Mate i-D/H Operation Maintenance Handbook

8. PARAMETERS
271
19) Parameters for canned cycles
Number
Contents Remarks
5101 Parameter for canned cycles PMi–D
#0 FXY : The drilling axis in drilling canned cycle is
always 1st axis (0)/an axis selected using
program (1)
#4 RD1 : Set the axis and direction in which the tool in
G76 and G87 is got free
#5 RD2 : Set the axis and direction in which the tool in
G76 and G87 is got free
#6 M5T : In tapping cycles G74 and G84, output M05
(0)/not output M05 (1) before the spindle
rotation direction is turned to reverse
#7 M5B : In drilling canned cycles G76 and G87, output
M05 before an oriented spindle stop (0)/not
output (1)
0
0
1
1
RD2 RD1
0
1
0
1
G17
+X
–X
+Y
–Y
G18
+Z
–Z
+X
–X
G19
+Y
–Y
+Z
–Z
5103 Canned cycle PMi–D
#1 QZA : When the specification of the depth of cut (Q)
for each time is omitted, or if Q0 is specified in
a highspeed peck drilling canned cycle (G73)
or peck drilling canned cycle (G83) no alarm is
issued (0)/an alarm (No.045) is issued (1)
ALM 045
5114 Return of high-speed, peck drilling cycle G73 PMi–D
5115 Clearance of canned cycle G83 PMi–D
20) Parameters for rigid tapping
Number
Contents Remarks
5200 Parameter for rigid tapping PMi–D
#0 G84 : G74 and G84 are not used as a rigid tapping G
code (0)/used (1)
#1 VGR : Any gear ration between spindle and position
coder in rigid tapping is not used (0)/used (1)
#2 CRG : When a rigid mode cancel command is
specified, the rigid mode is not canceled before
RGTAP signal is set low (0)/canceled (1)
#4 DOV : Override during extraction in rigid tapping is
invalidated (0)/validated (1)
#5 PCP : In rigid tapping, a high-speed peck tapping
cycle is used (0)/not used (1)
#6 FHD : Feed hold and single block in rigid tapping are
validated (0)/invalidated (1)
PRM5210
PRM3706,
5221 to
5234
PRM5211
PRM5213

Leave a Reply

Your email address will not be published. Required fields are marked *