Fanuc Power Mate i-D/H Operation Maintenance Handbook

3
1
4
5
6
7
8
9
10
2
274
21) Parameters for polar coordinate interpolation
Number
Contents Remarks
5460 Axis (linear axis) specification for polar
coordinate interpolation
5461 Axis (rotary axis) specification for polar
coordinate interpolation
5462 Maximum cutting feedrate during polar
coordinate interpolation [mm/min]
22) Parameters for straightness compensation
Number
Contents Remarks
5711 Axis number of moving axis
5721 Axis number of compensation axis 1 for moving
axis
5731 Compensation point number a of moving axis
5732 Compensation point number b of moving axis
5733 Compensation point number c of moving axis
5734 Compensation point number d of moving axis
5761 Compensation amount at compensation point
number a for a movement axis
5762 Compensation corresponding compensation
point number b of moving axis
5763 Compensation corresponding compensation
point number c of moving axis
5764 Compensation corresponding compensation
point number d of moving axis
23) Parameters for custom macro
Number
Contents Remarks
6000 Single block
#0 G67 : A G67 specified in modal call cancel mode
issues an alarm (0)/is ignored (1).
#1 MGO: When a GOTO statement is executed, a
high–speed branch to 20 sequence numbers
executed from the start of the program is, a
high–speed branch is not caused (0)/a
high–speed branch is caused (1)
#4 HGO: When a GOTO statement is executed a
high–speed branch is not caused (0)/a
high–speed branch is caused (1)
#5 SBM : In the custom macro statement, the single
block stop is not valid (0)/valid (1)

Leave a Reply

Your email address will not be published. Required fields are marked *