Fanuc Power Mate i-D/H Operation Maintenance Handbook

8. PARAMETERS
275
Number RemarksContents
6001 Initialization of the variables, T code call,
PRINT command
#1 PRT : When data is output using a DPRINT
command, outputs a space for reading zero
(0)/outputs no data (1)
#2 VFP : Specifies which to use, a custom macro
statement format (0) / the same format as for
Power MateA, B, or C (1), as the common
variable table output format.
#3 PV5 : The output macro variables are #500 and up
(0)/#100 and up and #500 and up (1).
#4 CRO : When ISO code is used in the B/D PRINT
mode, output only “LF” (0)/output “LF” and
“CR” (1)
#5 TCS : Custom macro is not called using a T code (0)/
called (1)
#6 CCV : Common variables #100 through #199 are
cleared to “vacant” by reset (0)/not cleared by
reset (1)
#7 CLV : Local variables #1 through #33 are cleared to
“vacant” by reset (0)/not cleared by reset (1)
O9000
6003 Interruption custom macro
#1 MSK : Absolute coordinate during custom macro
interrupt is not set to the skip coordinate (0)/set
(1)
#2 MIN : Custom macro interrupt is Type I (0)/Type II (1)
#3 TSE : Interrupt signal UNIT uses edge trigger method
(0)/status trigger method (1)
#4 MPR : M code for custom macro interrupt valid/invalid
is standard (M96/M97) (0)/using parameter
setting (1)
#5 MSB : The local variable of interrupt program is
macrotype (0)/subprogram type (1)
#6 MCY : Custom macro interrupt during cycle operation
is not performed (0)/performed (1)
#7 MUS : Interrupt-type custom macro is not used (0)/
used (1)
M96:
PRM6033
to 6034
6004 Result of ATAN, ASIN
#0 NAT : Specification of the results of custom macro
functions ATAN and ASIN ATAN = 0 to 360.0
ASIN = 270.0 to 0 to 90.0 (0)/ATAN = 180 to 0
to 180.0 ASIN = 90.0 to 0 to 90.0 (1)
6010 Setting of hole pattern “*” of EIA code (*0 to *7)
6011 Setting of hole pattern “=” of EIA code
(=0 to =7)
6012 Setting of hole pattern “#” of EIA code
(#0 to #7)
6013 Setting of hole pattern [ of EIA code ([0 to [7)
6014 Setting of hole pattern ] of EIA code (]0 to ]7)

Leave a Reply

Your email address will not be published. Required fields are marked *