Fanuc Power Mate i-D/H Operation Maintenance Handbook

3
1
4
5
6
7
8
9
10
2
SAFETY PRECAUTIONS
s–1
SAFETY PRECAUTIONS
This section describes the safety precautions related to the use of CNC
units. It is essential that these precautions be observed by users to
ensure the safe operation of machines equipped with a CNC unit (all
descriptions in this section assume this configuration). Note that some
precautions are related only to specific functions, and thus may not be
applicable to certain CNC units.
Users must also observe the safety precautions related to the machine,
as described in the relevant manual supplied by the machine tool
builder. Before attempting to operate the machine or create a program
to control the operation of the machine, the operator must become fully
familiar with the contents of this manual and relevant manual supplied
by the machine tool builder.
CONTENTS
1. DEFINITION OF WARNING, CAUTION, AND NOTE s–2. . . . . .
2. GENERAL WARNINGS AND CAUTIONS s–3. . . . . . . . . . . . . . .
3. WARNINGS AND CAUTIONS RELATED
TO PROGRAMMING s–5. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
4. WARNINGS AND CAUTIONS RELATED
TO HANDLING s–7. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
5. WARNINGS RELATED TO DAILY MAINTENANCE s–9. . . . . . .
6. RENAMING OF PMC MODELS s–12. . . . . . . . . . . . . . . . . . . . . . .

Leave a Reply

Your email address will not be published. Required fields are marked *