Fanuc Power Mate i-D/H Operation Maintenance Handbook

3
1
4
5
6
7
8
9
10
2
286
Number RemarksContents
7110 Number of manual pulse generator used
7113 Manual handle feed magnification m (1–127)
7114 Manual handle feed magnification n (0–1000)
7117 Allowable number of pulses that can be
accumulated during manual handle feed
PRM
7100#4=0
32) Parameters for butt-type reference position setting
Number
Contents Remarks
7181 First withdrawal distance in butt-type reference
position setting
7182 Second withdrawal distance in butt-type
reference position setting
7183 First butting feedrate in butt-type reference
position setting
7184 Second butting feedrate in butt-type reference
position setting
7185 Withdrawal feedrate (common to the first and
second butting operations) in butt-type
reference position setting
7186 Torque limit value in butt-type reference
position setting
33) Parameters for software operators panel
Number Contents Remarks
7200 Parameter for software operators panel
#0 OP1 : Mode selection is not performed on software
operator’s panel (0) /performed (1)
#1 OP2 : JOG feed axis selection is not performed on
software operators panel (0) / performed (1)
#2 OP3 : MPG’s axis selection is not performed on
software operators panel (0) / performed (1)
#3 OP4 : Override is not performed on software
operator’s panel (0) /performed (1)
#4 OP5 : OBS,SBK,MLK,DRN are not performed on
software operators panel (0) / performed (1)
#5 OP6 : Protect key is not performed on software
operator’s panel (0) / performed (1)
#6 OP7 : Feed hold is not performed on software
operator’s panel (0) / performed (1)
7201 General–purpose switch
#0 JPC : For the name of a generalpurpose switch
function on the software operators panel, the
use of fullsize characters is not allowed (0)/
allowed (1)

Leave a Reply

Your email address will not be published. Required fields are marked *