Fanuc Power Mate i-D/H Operation Maintenance Handbook

3
1
4
5
6
7
8
9
10
2
298
Number RemarksContents
8653 C executor
#0 CM1 : When the [CUSTOM/GRAPH] key is pressed,
the C executor screen defined by
CRT_USER_AUX is not displayed
(0)/displayed (1).
#1 CM2 : When the [CUSTOM/GRAPH] key is pressed,
the C executor screen defined by
CRT_USER_MCR is not displayed
(0)/displayed (1).
#2 CM3 : When the [CUSTOM/GRAPH] key is pressed,
the C executor screen defined by
CRT_USER_MENU is not displayed
(0)/displayed (1).
8661 Size of the variable area
8662 Size of the SRAM Disk
8663 Setting of the time zone
8701 Read method
#1 PLD : Read operation is performed after the P-code
loader is cleared (0)/without clearing the
P-code loader (1).
#2 WPR: The function that allows parameters that are
rewritten using the PMC window to be enabled
during automatic operation is disabled (0)/
enabled (1)
8705 Analog input function
#1 ADC : The analog input module is not used (0)/used
(1).
8706 High–speed response function PMi–H
#4 HMD: Auxiliary functions are not used (0)/used (1)
with the highspeed response function.
#5 CPL : Compile functions using signals are not used
(0)/used (1) with the highspeed response
function.
8730 Input voltage offset compensation value for the
analog input module
8731 High–speed skip signal PMi–H
#0 to #7 EP1 to EP7 : Specifies whether to use the
high–speed skip signals (bits 0 to
7 of X1003) as a trigger for an
interrupt–type PMC (1)/not to use
them for that purpose or use
them in measurement functions
by the highspeed skip signals
(0).

Leave a Reply

Your email address will not be published. Required fields are marked *