Fanuc Power Mate i-D/H Operation Maintenance Handbook

3
1
4
5
6
7
8
9
10
2
302
Number ContentsMessage
071 DATA NOT FOUND The address to be searched was not
found. Or the program with specified
program number was not found in
program number search.
Check the data.
072 TOO MANY PROGRAMS The number of programs to be stored
exceeded 63 (basic), 125 (option),
200 (option), or 400 (option). Delete
unnecessary programs and execute
program registeration again.
073 PROGRAM NUMBER
ALREADY IN USE
The commanded program number
has already been used.
Change the program number or de-
lete unnecessary programs and
execute program registeration
again.
074 ILLEGAL PROGRAM
NUMBER
The program number is other than 1
to 9999.
Modify the program number.
075 PROTECT An attempt was made to register a
program whose number was pro-
tected.
076 ADDRESS P NOT DEFINED Address P (program number) was
not commanded in the block which
includes an M98, G65, or G66 com-
mand. Modify the program.
077 SUB PROGRAM NESTING
ERROR
The subprogram was called in five
folds. Modify the program.
078 NUMBER NOT FOUND A program number or a sequence
number which was specified by ad-
dress P in the block which includes
an M98, M99, M65 or G66 was not
found. The sequence number speci-
fied by a GOTO statement was not
found. Otherwise, a called program
is being edited in background pro-
cessing. Correct the program, or dis-
continue the background editing.
079 PROGRAM VERIFY ERROR In memory or program collation, a
program in memory does not agree
with that read from an external I/O
device. Check both the programs in
memory and those from the external
device.
085 COMMUNICATION ERROR When entering data in the memory
by using Reader / Puncher interface,
an overrun, parity or framing error
was generated. The number of bits of
input data or setting of baud rate or
specification No. of I/O unit is incor-
rect.
086 DR SIGNAL OFF When entering data in the memory
by using Reader / Puncher interface,
the ready signal (DR) of reader /
puncher was turned off.
Power supply of I/O unit is off or
cable is not connected or a P.C.B. is
defective.

Leave a Reply

Your email address will not be published. Required fields are marked *