Fanuc Power Mate i-D/H Operation Maintenance Handbook

3
1
4
5
6
7
8
9
10
2
304
Number ContentsMessage
111 CALCULATED DATA
OVERFLOW
The result of calculation turns out to
be invalid, an alarm No.111 is issued.
–10
47
to –10
29
, 0, 10
29
to 10
47
Modify the program.
112 DIVIDED BY ZERO Division by zero was specified. (in-
cluding tan 90°)
Modify the program.
113 IMPROPER COMMAND A function which cannot be used in
custom macro is commanded.
Modify the program.
114 FORMAT ERROR IN
MACRO
There is an error in other formats
than <Formula>.
Modify the program.
115 ILLEGAL VARIABLE
NUMBER
A value not defined as a variable
number is designated in the custom
macro or in highspeed cycle ma-
chining.
Modify the program.
116 WRITE PROTECTED
VARIABLE
The left side of substitution state-
ment is a variable whose substitution
is inhibited. Modify the program.
118 PARENTHESIS NESTING
ERROR
The nesting of bracket exceeds the
upper limit (quintuple).
Modify the program.
119 ILLEGAL ARGUMENT The SQRT argument is negative. Or
BCD argument is negative, and other
values than 0 to 9 are present on
each line of BIN argument.
Modify the program.
122 FOUR FOLD MACRO
MODAL–CALL
The macro modal call is specified
four fold.
Modify the program.
123 CAN NOT USE MACRO
COMMAND IN DNC
Macro control command is used dur-
ing DNC operation.
Modify the program.
124 MISSING END STATEMENT DO – END does not correspond to 1
: 1. Modify the program.
125 FORMAT ERROR IN
MACRO
<Formula> format is erroneous.
Modify the program.
126 ILLEGAL LOOP NUMBER In DOn, 1x n x3 is not established.
Modify the program.
127 NC, MACRO STATEMENT
IN SAME BLOCK
NC and custom macro commands
coexist.
Modify the program.
128 ILLEGAL MACRO
SEQUENCE NUMBER
The sequence number specified in
the branch command was not 0 to
9999. Or, it cannot be searched.
Modify the program.
129 ILLEGAL ARGUMENT
ADDRESS
An address which is not allowed in
<Argument Designation > is used.
Modify the program.
130 ILLEGAL AXIS OPERATION An axis control command was given
by PMC to an axis controlled by
CNC. Or an axis control command
was given by CNC to an axis con-
trolled by PMC. Modify the program.

Leave a Reply

Your email address will not be published. Required fields are marked *