Fanuc Power Mate i-D/H Operation Maintenance Handbook

9. ERROR CODE LIST
307
Number ContentsMessage
5011 PARAMETER ZERO
(CUT MAX)
The maximum cutting feedrate (pa-
rameter No. 1422)is 0 in the HPCC
mode.
5046 ILLEGAL PARAMETER
(ST.COMP)
The parameter settings for straight-
ness compensation contain an error.
Possible causes are as follows:
1) A parameter for a movement axis
or compensation axis contains
an axis number which is not
used.
2) More than 128 pitch error com-
pensation points exist between
the negative and positive end
points.
3) Compensation point numbers for
straightness compensation are
not assigned in the correct order.
4) No straightness compensation
point exists between the pitch er-
ror compensation points at the
negative and positive ends.
5) The compensation value for
each compensation point is too
large or too small.
5051 M–NET CODE ERROR Abnormal character received (other
than code used for transmission)
5052 M–NET ETX ERROR Abnormal ETX code
5053 M–NET CONNECT ERROR Connection time monitoring error
(parameter No. 175)
5054 M–NET RECEIVE ERROR Polling time monitoring error
(parameter No. 176)
5055 M–NET PRT/FRT ERROR Vertical parity or framing error
5057 M–NET BOARD SYSTEM
DOWN
Transmission timeout error
(parameter No. 177)
ROM parity error
CPU interrupt other than the above
5120 NON A/D MODULE The analog input module is not con-
nected although the analog input
module enable parameter is set.
5121 A/D MODULE A/D converter error.
Replace the module.
5130 FRAME INSPECTION
SEQUENCE CONTAINS AN
ERROR
In the I/O LINK, the frame inspection
sequence contains an error.
5131 DATA LINK PROCEDURE
CONTAINS AN ERROR
In the I/O LINK, the data link proce-
dure contains an error.
5132 COMMUNICATION
MONITORING TIMEOUT
WAS DETECTED
In the I/O LINK, the communication
monitoring timeout was detected.
5133 OVERRUN ERROR WAS
DETECTED
In the I/O LINK, an overrun error was
detected.
5134 FSSB : OPEN READY TIME
OUT
Initialization did not place FSSB in
the open ready state.
5135 FSSB : ERROR MODE FSSB has entered error mode.

Leave a Reply

Your email address will not be published. Required fields are marked *