Fanuc Power Mate i-D/H Operation Maintenance Handbook

3
1
4
5
6
7
8
9
10
2
330
9.1.12 Error messages (for I/O)
(1) Error messages (for I/O (CRT))
Messages CONTENTS
PROGRAM ALREADY
EXISTS
A program is already stored in the FLASH ROM
(during blank check).
PROGRAM ALREADY
EXISTS (EXEC ?)
A program is already stored in the FLASH ROM
(during writing or deleting data).
Press the EXEC key again when the message is
displayed. Data is then written or deleted.
PROGRAM NOTHING No program is in the FLASH ROM.
ERASE ERROR The FLASH ROM is faulty and must be replaced.
F WRITE ERROR
Consult your FANUC service office.
L
A
READ ERROR
A
S
H
ANOTHER USED The FLASH ROM is being used by a device other
than the PMC.
R
O
M
MUST BE IN EMG
STOP NOT EMG
STOP
The CNC is not in the emergency stop state.
NO OPTION There is no ROM cassette option.
SIZE ERROR The size of the program exceeds the FLASH ROM
size (during writing of the sequence program).
Use the CONDENSEM function (EDIT/CLEAR
screen). If the error persists, the FLASH ROM size
must be increased.
The size of the program exceeds the RAM size
(during reading of the sequence program).
The RAM size must be increased.

Leave a Reply

Your email address will not be published. Required fields are marked *