Fanuc Power Mate i-D/H Operation Maintenance Handbook

9. ERROR CODE LIST
339
No. Contents
0011 The cutting feedrate is not correct.
There are two possible cases:
(1) The feedrate is not specified.
(2) The specified feedrate is 0.
0015 An attempt was made to move the machine along axes that exceeded the
maximum allowable number of simultaneously controlled axes in a single
block.
0053 A comma “,” is entered. (The comma “,” cannot be used.)
0070 The memory size is not sufficient.
0113 A # is entered.
(The # cannot be used in a specification other than travel distance and
speed specifications.)
0114 A macro statement is entered. (Macro statements cannot be used.)
0115 The variable number is invalid.
1000 A “/” is entered. (The “/” cannot be used.)
1001 G codes in groups 00 and 01 are specified in the same block.
1002 The number of words in a single block exceeded the permissible range.
1010 In a G31 block, no axis is specified, or two or more axes are specified.
1011 In a G31 block, an unusable P code is specified.
1020 In an M code block, a G code is specified.
1021 In an M code block an axis is specified.
1022 An unusable M code is specified.
1024 In an M code block, an invalid P is specified.
1025 In an M code block, P is not specified.
1027 In an M code block the feedrate F is specified.
1040 In a continuous feed block, no axis is specified, or two or more axes are
specified.
1091 In a block in which an optional block skip is specified, the feedrate F is
specified.
1094 In a block with an optional block skip, a G code in group 01 is specified.
1096 In a block with an optional block skip, a G code in group 03 is specified.
1100 No axis command is found in the program.
1101 No programs to be compiled (O8000 to O8031) can be found.
1102 In the compile function using a signal, a program number that cannot be
used in a motion program is specified.
1800 A motion program is under execution.
1821 An attempt was made to perform a compile operation in a reset state.
1822 An attempt was made to perform a compile operation when an alarm is
issued.
1823 An attempt was made to perform a compile operation while an NC pro-
gram was under execution.
1824 It is prohibited to edit programs O8000 to O8999.
1825 The program area is protected with a memory protection key.
1826 Background editing is in progress.

Leave a Reply

Your email address will not be published. Required fields are marked *