Fanuc Power Mate i-D/H Operation Maintenance Handbook

3
1
4
5
6
7
8
9
10
2
340
10.1 Dynamic Display of Sequence Program
(1) Display method
1 Press the
SYSTEM key, then press the soft key [PMC].
2 Dynamic display of sequence program by pressing [PMCLAD] soft
key.
(2) Display contents
[]
WINDOWSEARCH
[][][][]
ADRESS TRIGER
LADDER
NET 00010004 MONIT RUN
END1
LOG1
X008.4
LOG1
ALWAYS1
EMERGENCY
STOP
POWER ON
RESET
LOG1
*ESP
POR
PORD
Green
color
(dark) :
Signal is
turned
OFF
White
color
(bright) :
Signal is
turned
ON
Display of current net number
RUN/STOP
status
Comment
(3) Searching for the signal (SEARCH)
1 Press the [SEARCH] soft key.
2 Using the following keys as described below, search for desired
signal.
D The signals being displayed can be changed by using the
PAGE
,
PAGE
, , and keys.
D [TOP]: Locates the top of the ladder program.
D [BOTTOM] : Locates the end of the ladder program.
D
Address.bit [SRCH] or
Single name (symbol)
[SRCH] :
Search a specified address unconditionally.
D Address.bit [W-SRCH] or
Single name (symbol)
or
[W-SRCH] :
Searches for a specified address, for the write coils.
D
Net number [N-SRCH]:
Displays the ladder program from the specified net address.
D
Function instruction number [F-SRCH] or
Function instruction name [F-SRCH]: Searches for the
specified function instruction.
D [ADRESS]:
Displays the address and bit number of the specified signal.
D [SYMBOL]:
Displays the symbol of the specified signal. (The address of
the specified signal is displayed if a symbol was not specified
when the program was created.)
10. PMC

Leave a Reply

Your email address will not be published. Required fields are marked *