Fanuc Power Mate i-D/H Operation Maintenance Handbook

10. PMC
341
(4) Turning off the monitor display when the trigger signal changes
(TRIGER)
When the preset trigger signal changes, the system turns off the monitor
display. By using this function, the states of all signals can be accurately
read when the trigger signal changes.
1 Press the [TRIGER] soft key.
2 Press the [INIT] soft key to initialize the trigger parameters.
3 Specify the trigger conditions.
D To turn off the monitor display at the signals rising edge (as the
signal changes from 0 to 1), enter the desired data and press
the required keys in the order shown below.
Count
Signal name/address Trigger checkpoint
[TRGON]
EOB EOB
: Trigger checkpoint:
0: Before the first level of the ladder program is executed
1: After the first level of the ladder program is executed
2: After the second level of the ladder program is executed
3: After the third level of the ladder program is executed
Example) To set the system so that it turns off the monitor display when
the external reset signal (ERS) is input three times, enter the
required data and press the required keys in the order
shown below:
ERS
[TRGON]
EOB
2 3
EOB
The specified trigger conditions are displayed at the top of the screen.
TRIGER *MODE : ON G008. 7 : 2 : 003 NET 0001-00005
Specified conditions are displayed.
To turn off the monitor display at the signals falling edge (as the signal
changes from 1 to 0), enter the desired data and press the required keys
in the order shown below.
Count
Signal name/address Trigger checkpoint
[TRGOFF]
EOB EOB
4 Press the [START] soft key to activate the trigger function.
: While the trigger function is operating,
TRG is displayed at
the lower right corner of the screen. When the trigger
conditions are satisfied,
TRG disappears and the monitor
screen is locked.
5 To interrupt the trigger function, press the [STOP] soft key while the
function is effective.
³ In this case, the specified trigger conditions remain effective.
Pressing the [START] soft key reinstates the trigger function.
6 To search for the instruction where the program was stopped by the
trigger function and blink that instruction, press the [TRGSRC] soft
key.

Leave a Reply

Your email address will not be published. Required fields are marked *