Fanuc Power Mate i-D/H Operation Maintenance Handbook

3
1
4
5
6
7
8
9
10
2
350
(a) [SCOPE] soft key : Select the signal wave display screen.
(b) [DELETE] soft key : Delete of the data on the cursor.
(c) [INIT] soft key :Initializes the signal waveform display
parameters.
(d) [ADRESS] or [SYMBOL] soft key : Toggles between address
display and symbol display.
SGNPRM
[][][][ ][]
START T.SRCH ADDRESS
PMC SIGNAL ANALISYS(PARAM)
SAMPLING TIME : 10 CONDITION : 1
TRIGGER ADDRESS: G0007.2 TRIGGER MODE : 0
MONIT STOP
0 256(MSEC)
X0000.0
X0000.1
X0002.0
X0005.0
NOTE The above figure is a screen for the attachment to a graphic func-
tion.
If a graphic function is not attached, it is displayed
J .
(a) [SGNPRM] soft key : Return to PMC parameter screen
(b) [START] soft key : Start register
(c) [T. SRCH] soft key :
(d) [ADRESS] or [SYMBOL] soft key : Change to address or sym-
bol of signal.
(e) [EXCHG] soft key : Change the signal displaying procedure
D Press [EXCHG] soft key.
D Move the cursor to an exchanging signal.
D Press [SELECT] soft key.
D Move the cursor to one s new address.
D Exchange the signal when press [TO] soft key then press
[EXEC] soft key.
(f) [SCALE] soft key : Change the holizontal scaling time for
graphics.
Scaling time is changed 256, 512 and
1024msec when press this key.
(g)
CURSOR : Move the holizontal time of displaying
on CRT to BEFORE/REVERSE.

Leave a Reply

Your email address will not be published. Required fields are marked *