Fanuc Power Mate i-D/H Operation Maintenance Handbook

3
1
4
5
6
7
8
9
10
2
354
K018
or
K901
#7 #6 #5 #4 #3 #2 #1 #0
CHKPRTY CALCPRTY
TRNSRAM TRGSTAT
#5 (CHKPRTY) 0 : The system performs parity check for the system
ROM, program ROM and program RAM.
1 : The system does not perform parity check for the
system ROM, program ROM, or program RAM.
#4 (CALCPRTY)0 : The built-in programmer function calculates the
RAM parity.
1 : The built-in programmer function does not
calculate the RAM parity.
#3 (TRNSRAM) 0 : After on-line editing, the ladder program is not
automatically transferred to the backup RAM.
1 : After on-line editing, the ladder program is
automatically transferred to the backup RAM.
#2 (TRGSTAT) 0 : The trigger stop function does not automatically
start at power on.
1 : The trigger stop function starts automatically at
power on.
K019
or
K902
#7 #6 #5 #4 #3 #2 #1 #0
FROM–WRT
#0 (FROM_WRT) 0 : After editing a ladder, does not automatically
write it to F–ROM.
1 : After editing a ladder, automatically writes it to
F–ROM.
NOTE Set all unused bits to 0.
10.3.5 Data table screen (DATA)
1) DATA TABLE SETTING screen (C. DATA)
INITNO.SRHG.CONTG.DATA
[]
NO. ADDRESS PARAMETER TYPE NO.OF DATA
001 D0000 00000000 0 10
002 D0020 00000011 1 20
003
004
005
006
007
008
PMC DATA TBL CONTROL #001
GROUP TABLE COUNT = 2
[][][][]
MONIT RUN
Number
of data
table
group
Number
of data of
each data
table
Data
length
Table
parameter
Head
address of
data table
(a) [G.DATA] soft key : Select the data display screen of data table.
(b) No. of group [G.CONT] : Set the number of group for data table.
(c)
No. of group [NO.SRH] : Move the cursor to specified group.

Leave a Reply

Your email address will not be published. Required fields are marked *