Fanuc Power Mate i-D/H Operation Maintenance Handbook

3
1
4
5
6
7
8
9
10
2
356
10.3.6 Setting screen
Part of the keep relay parameters can be set on this screen.
NO
[][][][][]
YES
PMC PRM (SETTING)
MONIT RUN
PROGRMMER ENABEL = 0(0:NO 1:YES)
LADDER START = 0(0:AUTO 1:MANUAL)
RAM WRITE ENABLE = 0(0:NO 1:YES)
SIGNAL TRACE START = 0(0:MANUAL 1:AUTO)
SIGNAL ANALYS START = 0(0:MANUAL 1:AUTO)
DATA TBL CNTL SCREEN = 0(0:YES 1:NO)
SIGNAL TRIGGER START = 0(0:MANUAL 1:AUTO)
TRANS LADDER (ONLEDT) = 0(0:MANUAL 1:AUTO)
For SB5
(K17.1)
(K17.2)
(K17.4)
(K17.5)
(K17.6)
(K17.7)
(K18.2)
(K-18.7):
For SB6
(K900.1)
(K900.2)
(K900.4)
(K900.5)
(K900.6)
(K900.7)
(K901.2)
(K901.3)
: Values in parentheses indicate the addresses of the corresponding
keep relays.

Leave a Reply

Your email address will not be published. Required fields are marked *