Fanuc Power Mate i-D/H Operation Maintenance Handbook

3
1
4
5
6
7
8
9
10
2
26
1.2.9 Displaying and setting the data
(1) Press soft key [SETING].
OFFSET
[][][][][]
SETING (OPRT)
SETTING (HANDY) O0000 N00000
PARAMETER WRITE = 1 (0 : DISABLE 1 : ENABLE)
TV CHECK = 0 (0 : OFF 1 : ON)
PUNCH CODE = 1 (0 : EIA 1 : ISO)
INPUT UNIT = 0 (0 : MM 1 : INCH)
I/O CHANNEL = 0 (03 : CHANNEL NO.)
SEQUENCE NC. = 0 (0 : OFF 1 : ON)
>_
MDI **** *** *** 15:06:56
ALM 100
ALM 002
G20/G21
Parameter
(No.3216)
OFFSET
[][][][][]
SETING (OPRT)
SETTING (MIRROR IMAGE) O1234 N00000
MIRROR IMAGE X = (0 : OFF 1 : ON)
MIRROR IMAGE Y = 0 (0 : OFF 1 : ON)
MIRROR IMAGE Z = 0 (0 : OFF 1 : OM)
>_
MDI **** *** *** 14:47:57
Signal
(MMIx) indi-
cating that
mirror image
processing is
in progress
1
OFFSET
[][][][][]
SETING (OPRT)
SETTING (TIMER) O0000 N00000
PARTS TOTAL = 0
PARTS REQUIRED = 25
PARTS COUNT = 10
POWER ON = 0H 0M
OPERATING TIME = 0H 0M 0S
CUTTING TIME = 0H 0M 0S
FREE PURPOSE = 0H 0M 0S
CYCLE TIME = 0H 0M 0S
DATE = 95/10/04
TIME = 16:18:01
>_
MEM **** *** *** 14:47:57
(No.6712)(*1)
(No.6713)
(No.6750)(*1)
Parameter
(No.6751,6752)
(No.6711)
(No.6753,6754)
(No.6755,6756)
(No.6758,6759)
Not incremented if the parameter for disabling the display of the
operation time and the number of parts (bit 7 of No. 6700) is set.
2000
NOTE *1 Cannot be changed on this screen (but can be changed on the
parameter screen).)

Leave a Reply

Your email address will not be published. Required fields are marked *