Fanuc Power Mate i-D/H Operation Maintenance Handbook

3
1
4
5
6
7
8
9
10
2
s–3
2. GENERAL WARNINGS AND CAUTIONS
WARNING
1. Never attempt to machine a workpiece without first
checking the operation of the machine. Before starting a
production run, ensure that the machine is operating
correctly by performing a trial run using, for example, the
single block, feedrate override, or machine lock function
or by operating the machine with neither a tool nor
workpiece mounted. Failure to confirm the correct
operation of the machine may result in the machine
behaving unexpectedly, possibly causing damage to the
workpiece and/or machine itself, or injury to the user.
2. Before operating the machine, thoroughly check the
entered data.
Operating the machine with incorrectly specified data
may result in the machine behaving unexpectedly,
possibly causing damage to the workpiece and/or
machine itself, or injury to the user.
3. Ensure that the specified feedrate is appropriate for the
intended operation. Generally, for each machine, there is
a maximum allowable feedrate. The appropriate feedrate
varies with the intended operation. Refer to the manual
provided with the machine to determine the maximum
allowable feedrate. If a machine is run at other than the
correct speed, it may behave unexpectedly, possibly
causing damage to the workpiece and/or machine itself,
or injury to the user.
4. When using a tool compensation function, thoroughly
check the direction and amount of compensation.
Operating the machine with incorrectly specified data
may result in the machine behaving unexpectedly,
possibly causing damage to the workpiece and/or
machine itself, or injury to the user.
5. The parameters for the CNC and PMC are factory–set.
Usually, there is not need to change them. When,
however, there is not alternative other than to change a
parameter, ensure that you fully understand the function
of the parameter before making any change.
Failure to set a parameter correctly may result in the
machine behaving unexpectedly, possibly causing
damage to the workpiece and/or machine itself, or injury
to the user.
6. Immediately after switching on the power, do not touch
any of the keys on the MDI panel until the position display
or alarm screen appears on the CNC unit.
Some of the keys on the MDI panel are dedicated to
maintenance or other special operations. Pressing any
of these keys may place the CNC unit in other than its
normal state. Starting the machine in this state may
cause it to behave unexpectedly.

Leave a Reply

Your email address will not be published. Required fields are marked *