Fanuc Power Mate i-D/H Operation Maintenance Handbook

1. SCREEN DISPLAY AND OPERATION
45
1.4 BOOT SYSTEM
J The BOOT system of the Power Mate iD/H loads NC control software
and P-CODE programs from the FROM (flash ROM) into the DRAM
when the power is turned on, subsequently operating according to that
data.
J In addition to the above, the BOOT system supports the following
functions:
D Writing files from a memory card to the FROM
D Displaying a directory of files in the FROM
D Deleting files from the FROM
D Writing user files, stored in the FROM, to a memory card
D Inputting/outputting data to and from the SRAM as a batch
D Deleting files stored on a memory card
D Formatting a memory card
F Displaying the SYSTEM MONITOR MAIN MENU screen
1 Turn on the power while holding down both the rightmost soft key
(continuation key) and the soft key to its left.
[][][][][]
Turn on the power while holding
down these two soft keys.
D If FANUC touch panel is used, press the upper left corner of the
touch panel screen until the BOOTSYSTEM screen appears. To
manipulate the screen, touch labels on the softkey menu.
2 The SYSTEM MONITOR MAIN MENU screen appears.
SELECT
[][][][][]
YES NO UP DOWN
SYSTEM MONITOR MAIN MENU 881I–01
1. SYSTEM DATA LOADING
2. SYSTEM DATA CHECK
3. SYSTEM DATA DELETE
4. SYSTEM DATA SAVE
5. SRAM DATA BACKUP
6. MEMORY CARD FILE DELETE
7. MEMORY CARD FORMAT
10.END
***MESSAGE***
SELECT MODE AND HIT SELECT KEY.
3 Using the [UP] or [DOWN] soft key, position the cursor to the
desired item.

Leave a Reply

Your email address will not be published. Required fields are marked *