Fanuc Power Mate i-D/H Operation Maintenance Handbook

1. SCREEN DISPLAY AND OPERATION
55
F Formatting a memory card (MEMORY CARD FORMAT screen)
D A newly purchased memory card must be formatted before it can
be used. Also, a memory card must be formatted if its contents are
destroyed or lost due to battery failure.
(1) Select the MEMORY CARD FORMAT screen.
1 Using the [UP] or [DOWN] soft key, position the cursor to 7.
MEMORY CARD FORMAT on the SYSTEM MONITOR MAIN
MENU screen.
2 Press the [SELECT] key.
(2) A confirmation message appears at the bottom of the screen. To format
the memory card, press the [YES] soft key. To abandon the formatting,
press the [NO] soft key.
D While the memory card is being formatted, the message
FORMATTING MEMORY CARD is displayed at the bottom of the
screen.
D Once formatting has been completed, “FORMATTING
COMPLETE HIT. SELECT KEY appears at the bottom of the
screen.
(3) Press the [SELECT] soft key to return to the SYSTEM MONITOR MAIN
MENU screen.
F Quit system monitoring
(1) Quit system monitoring.
1 Using the [UP] or [DOWN] soft key, position the cursor to 10. END
on the SYSTEM MONITOR MAIN MENU.
2 Press the [SELECT] soft key.
SELECT
[][][][][]
YES NO UP DOWN
SYSTEM MONITOR MAIN MENU
1. SYSTEM DATA LOADING
2. SYSTEM DATA CHECH
3. SYSTEM DATA DELETE
4. SYSTEM DATA SAVE
5. SRAM DATA BACKUP
6. MEMORY CARD FILE DELETE
7. MEMORY CARD FORMAT
10.END
60M1–02
***MESSAGE***
SELECT MODE AND HIT SELECT KEY.
(2) To quit system monitoring, press the [YES] soft key.
To continue system monitoring, press the [NO] soft key.
³
The NC system starts in the same way as when the power
is first turned on. The following messages are displayed on
the screen:
CHECK CNC BASIC SYSTEM
±
LOADING BASIC CNC TO DRAM

Leave a Reply

Your email address will not be published. Required fields are marked *