Fanuc Power Mate i-D/H Operation Maintenance Handbook

1. SCREEN DISPLAY AND OPERATION
63
F Operation procedure
Selecting7.MEMORY CARD FORMAT causes the confirmation
screen, shown below, to appear. Pressing <ENTER> to start
formatting.
CARD FORMAT OK?
HIT [Y] OR [N]
: Confirmation screen
The “HIT [Y] OR [N] indication flashes.
While formatting is in progress, the screen shown below appears.
CARD FORMAT
EXEC
: The “EXEC” indication flashes.
Upon the completion of formatting, the system returns to the initial screen.
LOAD BASIC SYSTEM
This screen is used to terminate BOOT SYSTEM and start the Power
Mate i.
F Operation procedure
Selecting10.SYSTEM MONITOR EXIT causes the confirmation
screen, shown below, to appear. Pressing [Y] causes loading of CNC
system data to DRAM to start and the INIT operation window to start.
Selecting [N] returns the system to the initial screen.
MONITOR EXIT OF?
HIT [Y] OR [N]
: Confirmation screen
The “HIT [Y] OR [N] indication flashes.
While loading is in progress, the screens shown below appear sequentially.
CHECK CNC BASIC
SYSTEM
LOADING BASIC
TO DRAM
CNC BASIC
LOADED
±The INIT operation window starts.
INIT SYSTEM operation method
If the power is turned off while an NC program is being edited or if the
contents of SRAM are destroyed due to a noise or for other reasons, the
power–on time operation, including memory clear, can be executed
when the power is turned on.
Startup procedure
This window is automatically started after “BOOTINIT.EXE” is started
up with the BOOT SYSTEM startup procedure and then
BOOTSYSTEM is terminated.
Operation method
Selecting “INIT” from the main menu in this window and selecting any
of the items from the pulldown menu causes that operation to be
executed.
MEMORY ALL CLEAR
Clear all memory
MEMORY CLEAR (PARAMETER,OFFSET)
Clear CNC parameters and offsets

Leave a Reply

Your email address will not be published. Required fields are marked *