Fanuc Power Mate i-D/H Operation Maintenance Handbook

2. OPERATION LIST
65
2.1 CRT/MDI (FANUC Touch Panel)
Reset
Function
KEY
SW
PWE
= 1
Mode
Function
key
Operation
Operating
time
POS
[(OPRT)] [TIME: 0]
[EXEC]
Number of
machined
parts
POS
[(OPRT)] [PART: 0]
[EXEC]
OT alarm
(software)
At pow-
er-up
and
CAN
Pc
Alarm 100
CAN
RESET
FANUC touch panel
ENTER
SPCL
RESET
CRT
and
CAN
(FANUC touch panel)
If a FANUC touch panel is used, normal power–ON–time key operations
cannot be performed. Perform the following:
À Press and hold down the upper right corner of the touch panel screen
and turn the power on. This causes the CNC system initialization
operation screen to appear.
Á For “KEY1” and “KEY2” on the screen that appears, enter the
characters corresponding to the keys to be pressed at power ON.
 Press the EXIT soft key. The same processing as that performed when
CRT keys are pressed and held down and the power is turned is
performed, and the CNC starts.
NOTE 1 When the RESET and DELET key combination or the 7 and 9 key
combination is pressed for memory all clear operation, two–path
control is switched to onepath control.
Registration from MDI
Function
KEY
SW
PWE
= 1
Mode
Function
key
Operation
Parameter f
SYSTEM
[PARAM] Parameter No.
[NO.SRH] Data
or [INPUT] PWE = 0
INPUT
RESET
Offset f
SETTING
OFFSET
[OFFSET] Offset No.
[NO. SRH] Offset value
or [INPUT]
INPUT
Setting
data
f
SETTING
OFFSET
[SETTING] Setting No.
[NO. SRH]Data
or [INPUT]
INPUT

Leave a Reply

Your email address will not be published. Required fields are marked *