Fanuc Power Mate i-D/H Operation Maintenance Handbook

3
1
4
5
6
7
8
9
10
2
70
Function Operation
Function
key
Mode
PWE
= 1
KEY
SW
Program
clear
f At pow-
er-up
DELETE
Path 1 side of twopath con-
trol
and
DELETE
1
Path 2 side of twopath con-
trol
and
DELETE
2
Program
being
edited at
power
failure
(PS101)
and
PROG
RESET
Ladder
clear
At pow-
er-up
and
X 0
PMC
nonvolatile
memory
At pow-
er-up
and
ZO
(FANUC touch panel)
If a FANUC touch panel is used, normal power–ON–time key operations
cannot be performed. Perform the following:
À Press and hold down the upper right corner of the touch panel screen
and turn the power on. This causes the CNC system initialization
operation screen to appear.
Á For “KEY1” and “KEY2” on the screen that appears, enter the
characters corresponding to the keys to be pressed at power ON.
 Press the EXIT soft key. The same processing as that performed when
CRT keys are pressed and held down and the power is turned is
performed, and the CNC starts.
NOTE 1 When the RESET and DELET key combination or the 7 and 9 key
combination is pressed for memory all clear operation, two–path
control is switched to onepath control.
Path control switching (PowerMate i–D)
When twopath control is switched to onepath control or vice versa, all
CNC data including parameters and programs is cleared. Parameters are
set again to factory settings. However, option parameters are not cleared.
Once path control is switched, the new setting remains effective even after
power is turned off. It does not need to be set at each power–up.
Function
KEY
SW
PWE
= 1
Mode
Function
key
Operation
From one
path con-
trol to two
path con-
trol
At pow-
er–up
and
S
2
From two
path con-
trol to
one–path
control
At pow-
er–up
and
S
1

Leave a Reply

Your email address will not be published. Required fields are marked *