Fanuc Power Mate i-D/H Operator Manual

PROGRAMMING
(Common to Power Mate i–D and –H)
11. PROGRAM CONFIGURATION
B–63174EN/03
84
A tape end is to be placed at the end of a file containing NC programs.
If programs are entered using the automatic programming system, the
mark need not be entered.
The tape end code is not displayed on the screen. When a file is output,
however, the tape end code is automatically output at the end of the file.
If an attempt is made to execute % when M02 or M03 is not placed at the
end of the program, the alarm (No.5010) is occurred.
Table 11.1 (d) Code of a tape end
Name
ISO
code
EIA
code
Notation in this
manual
Tape end % ER %
Tape end

Leave a Reply

Your email address will not be published. Required fields are marked *