Fanuc Power Mate i-D/H Operator Manual

PROGRAMMING
(Common to Power Mate i–D and –H)
11. PROGRAM CONFIGURATION
B–63174EN/03
88
Major addresses and the ranges of values specified for the addresses are
shown below. Note that these figures represent limits on the CNC side,
which are totally different from limits on the machine tool side. For
example, the CNC allows a tool to traverse up to about 100 m (in
millimeter input) along the X axis.
However, an actual stroke along the X axis may be limited to 2 m for a
specific machine tool.
Similarly, the CNC may be able to control a feedrate of up to 240 m/min,
but the machine tool may not allow more than 3 m/min. When developing
a program, the user should carefully read the manuals of the machine tool
as well as this manual to be familiar with the restrictions on programming.
Table 11.2 (c) Major addresses and ranges of command values
Function Address Input in mm Input in inch
Program number O (NOTE1) 1 to 9999 1 to 9999
Sequence number N 1 to 99999 1 to 99999
Preparatory function G 0 to 99 0 to 99
Dimension
word
Increment system IS–A
(NOTE1)
X, Y, Z, U, V,
W, A, B, C, I,
999999.99mm 99999.999inch
Increment system IS–B
J, K, R
99999.999mm 9999.9999inch
Increment system IS–C 9999.9999mm 999.99999inch
Feed per
minute
Increment system IS–A
(NOTE1)
F 1 to 240000mm/min 0.01 to 9600.00inch/min
Increment system IS–B 1 to 240000mm/min 0.01 to 9600.00inch/min
Increment system IS–C 1 to 100000mm/min 0.01 to 4000.00inch/min
Feed per revolution F 0.001 to 500.00mm/rev 0.0001 to 9.9999inch/rev
Spindle speed function (NOTE1) S 0 to 20000 0 to 20000
Tool function T 0 to 99999999 0 to 99999999
Auxiliary function M 0 to 99999999 0 to 99999999
Offset number H 0 to 99 0 to 99
Dwell Increment system IS–A
(NOTE1)
X, P 0 to 999999.99s 0 to 999999.99s
Increment system IS–B 0 to 99999.999s 0 to 99999.999s
Increment system IS–C 0 to 9999.9999s 0 to 9999.9999s
Designation of a program number P 1 to 9999 1 to 9999
Number of repetitions P 1 to 999 1 to 999
NOTE
1 IS–A is available only for Power Mate i–H.
Spindle function are available only for Power Mate i–D/D2.
2 In ISO code, the colon (:) can also be used as the address
of a program number.
Major addresses and
ranges of command
values

Leave a Reply

Your email address will not be published. Required fields are marked *