Fanuc Power Mate i-D/H Operator Manual

PROGRAMMING
(Common to Power Mate i–D and –H)
11. PROGRAM CONFIGURATION
B–63174EN/03
94
The 8–digit program number function enables specification of program
numbers with eight digits following address O (O00000001 to
O99999999).
Whether a program number after address O is to be 4 digits or 8 digits long
can be chosen by using bit 6 of parameter No. 3230.
Editing of subprograms O00008000 to O00008999, O00009000 to
O00009999, O80000000 to O89999999, and O90000000 to O99999999
can be disabled.
Parameter Program numbers for which editing is disabled
NE8(No.3202#0) O00008000 to O00008999
NE9(No.3202#4) O00009000 to O00009999
PRG8E(No.3204#3) O80000000 to O89999999
PRG9E(No.3204#4) O90000000 to O99999999
For program punch by specifying a range, files are named as follows:
When punching by specifying O00000001 and O00123456:
“O00000001–G”
When punching by specifying O12345678 and O45678900:
“O12345678–G”
When 2–path control is being applied, the file name for the path 1 side is
suffixed with “–1” and that for the path 2 side is suffixed with “–2.”
Special subprogram numbers can be changed by using bit 5 (SPR) of
parameter No.3204.
1) Macro call using G code
Parameter used to
Program number
Parameter
used
to
specify G code
When SPR = 0 When SPR = 1
No.6050
No.6051
No.6052
No.6053
No.6054
No.6055
No.6056
No.6057
No.6058
No.6059
O00009010
O00009011
O00009012
O00009013
O00009014
O00009015
O00009016
O00009017
O00009018
O00009019
O90009010
O90009011
O90009012
O90009013
O90009014
O90009015
O90009016
O90009017
O90009018
O90009019
2) Macro call using M code
Parameter used to
Program number
Parameter
used
to
specify M code
When SPR = 0 When SPR = 1
No.6080
No.6081
No.6082
No.6083
No.6084
No.6085
No.6086
No.6087
No.6088
No.6089
O00009020
O00009021
O00009022
O00009023
O00009024
O00009025
O00009026
O00009027
O00009028
O00009029
O90009020
O90009021
O90009022
O90009023
O90009024
O90009025
O90009026
O90009027
O90009028
O90009029
11.4
8–DIGIT PROGRAM
NUMBER
Explanations
Selection of the number
of digits of a program
number
Disabling editing of
programs
File name
Special programs

Leave a Reply

Your email address will not be published. Required fields are marked *