Fanuc Power Mate i-D/H Operator Manual

PROGRAMMING
(Common to Power Mate i–D and –H)
B–63174EN/03
11. PROGRAM CONFIGURATION
95
3) Subprogram call using M code
Parameter used to
Program number
Parameter
used
to
specify M code
When SPR = 0 When SPR = 1
No.6071
No.6072
No.6073
No.6074
No.6075
No.6076
No.6077
No.6078
No.6079
O00009001
O00009002
O00009003
O00009004
O00009005
O00009006
O00009007
O00009008
O00009009
O90009001
O90009002
O90009003
O90009004
O90009005
O90009006
O90009007
O90009008
O90009009
4) Macro call using T code
Parameter used to
Program number
Parameter
used
to
specify T code
When SPR = 0 When SPR = 1
TCS(No.6001#5) O00009000 O90009000
5) Macro call using ASCII code
Parameter used to
Program number
Parameter
used
to
specify ASCII code
When SPR = 0 When SPR = 1
No.6090
No.6091
O00009004
O00009005
O90009004
O90009005
6) Pattern data function
Program numaber
When SPR = 0 When SPR = 1
O00009500
O00009501
O00009502
O00009503
O00009504
O00009505
O00009506
O00009507
O00009508
O00009509
O00009510
O90009500
O90009501
O90009502
O90009503
O90009504
O90009505
O90009506
O90009507
O90009508
O90009509
O90009510
The repetition function of subprogram call is disabled.
The count of the repetition might be one.
(Example)
M98 P12345678
;
Subprogram number only. The repetition count is
not included.
Limitations
Subprogram call

Leave a Reply

Your email address will not be published. Required fields are marked *