Fanuc Power Mate i-D/H Operator Manual

PROGRAMMING
(Common to Power Mate i–D and –H)
13. CUSTOM MACRO
B–63174EN/03
112
When feed hold is disabled:
(1) When the feed hold button is held down, the machine stops in the
single block stop mode. However, single block stop operation is
not performed when the single block mode is disabled with
variable #3003.
(2) When the feed hold button is pressed then released, the feed hold
lamp comes on, but the machine does not stop; program
execution continues and the machine stops at the first block
where feed hold is enabled.
When feedrate override is disabled, an override of 100% is always
applied regardless of the setting of the feedrate override switch on the
machine operators panel.
When exact stop check is disabled, no exact stop check (position
check) is made even in blocks including those which do not perform
feed at programmed rate.
O0001 ;
N1 G00 G91 X#24 ;
N2 Z#18 ;
G04 ;
N3 #3003=3 ;
N4 #3004=7 ;
N5 G01 Z#26 F#9 ;
N6 M04 ;
N7 G01 Z–[ROUND[#18]+ROUND
[#26]] ;
G04 ;
N8 #3004=0 ;
N9 #3003=0 ;
N10M03 ;
M99 ;
N1
N2
N3, N4
N6
N7
N8, N9,
N10
N5
Fig.13.2 Example of using variable #3004 in a tapping cycle
Settings can be read and written. Binary values are converted to
decimals.
#5 (SEQ) : Whether to automatically insert sequence numbers
#2 (INI) : Millimeter input or inch input
#1 (ISO) : Whether to use EIA or ISO as the output code
#0 (TVC) : Whether to make a TV check
#15 #14 #13 #12 #11 #10 #9 #8
Setting
#7 #6 #5 #4 #3 #2 #1 #0
SEQ INI ISO TVC
Setting
#3005
Settings

Leave a Reply

Your email address will not be published. Required fields are marked *