Fanuc Power Mate i-D/H Operator Manual

PROGRAMMING
(Common to Power Mate i–D and –H)
B–63174EN/03
13. CUSTOM MACRO
115
The tool position where the skip signal is turned on in a G31 (skip
function) block is held in variables #5061 to #5068. When the skip
signal is not turned on in a G31 block, the end point of the specified
block is held in these variables.
When read during movement is “disabled,” this means that expected
values cannot be read due to the buffering (preread) function.
The selected pattern number can be read.
Table 13.2 (j) System variable for pattern data input information
Variable number Function
#5900 Selected pattern number
Pattern data input
information

Leave a Reply

Your email address will not be published. Required fields are marked *