Fanuc Power Mate i-D/H Operator Manual

PROGRAMMING
(Common to Power Mate i–D and –H)
B–63174EN/03
13. CUSTOM MACRO
121
The following blocks are referred to as macro statements:
Blocks containing an arithmetic or logic operation (=)
Blocks containing a control statement (such as GOTO, DO, END)
Blocks containing a macro call command (such as macro calls by
G65, G66, G67, or other G codes, or by M codes)
Any block other than a macro statement is referred to as an NC statement.
Even when single block mode is on, the machine does not stop. Note,
however, that the machine stops in the single block mode when bit 5
(SBM) of parameter 6000 is 1.
NC statements that include a subprogram call command (such as
subprogram calls by M98 or other M codes, or by T codes) and also
include an O, N, P, or L address have the same property as macro
statements.
NC statements that include M99 and an O, N, L, or P address have the
same property as macro statements.
13.4
MACRO
STATEMENTS AND
NC STATEMENTS
Explanations
Differences from NC
statements
NC statements that have
the same property as
macro statements

Leave a Reply

Your email address will not be published. Required fields are marked *