Fanuc Power Mate i-D/H Operator Manual

1. SPINDLE SPEED FUNCTION
(S FUNCTION)
PROGRAMMING
(For the Power Mate i–D/D2)
B–63174EN/03
173
1
SPINDLE SPEED FUNCTION (S FUNCTION)
The spindle speed can be controlled by specifying a value following
address S.
This chapter contains the following topics.
1.1 SPECIFYING THE SPINDLE SPEED WITH A BINARY CODE
1.2 SPECIFYING THE SPINDLE SPEED VALUE DIRECTLY
(S5–DIGIT COMMAND)
1.3 CONSTANT SURFACE SPEED CONTROL (G96, G97)

Leave a Reply

Your email address will not be published. Required fields are marked *