Fanuc Power Mate i-D/H Operator Manual

1. SPINDLE SPEED FUNCTION
(S FUNCTION)
PROGRAMMING
(For the Power Mate i–D/D2)
B–63174EN/03
174
This spindle speed can be specified by address S followed by a binary
code. A block can contain only one S code. Refer to the appropriate
manual provided by the machine tool builder for details such as the
number of digits in an S code or the execution order when a move
command and an S code command are in the same block.
The spindle speed can be specified directly by address S followed by a
five–digit value (min
–1
). The unit for specifying the spindle speed may
vary depending on the machine tool builder. Refer to the appropriate
manual provided by the machine tool builder for details.
1.1
SPECIFYING THE
SPINDLE SPEED
WITH A BINARY
CODE
1.2
SPECIFYING THE
SPINDLE SPEED
VALUE DIRECTLY
(S5–DIGIT
COMMAND)

Leave a Reply

Your email address will not be published. Required fields are marked *