Fanuc Power Mate i-D/H Operator Manual

2. FUNCTION TO SIMPLIFY
PROGRAMMING
PROGRAMMING
(For the Power Mate i–D/D2)
B–63174EN/03
187
Before the drilling axis can be changed, the canned cycle must be
canceled.
In a block that does not contain X, Z, R, or any additional axes, boring is
not performed.
Be sure to specify a positive value in Q. If Q is specified with a negative
value, the sign is ignored. Set the direction of shift in bits 4 (RD1) and
5 (RD2) of parameter No. 5101. Specify Q and R in a block that performs
boring. If they are specified in a block that does not perform boring, they
are not stored as modal data.
Do not specify a group 01 G code (G00 to G03) and G76 in the same block.
If they are specified together, G76 is canceled.
In the canned cycle mode, tool offsets are ignored.
M3 S500 ; Cause the spindle to start rotating.
G90 G76 X300. Position, bore hole 1, then return to initial level.
Z–150. R–120. Q5. Orient at the bottom of the hole, then shift by
5 mm.
P1000 F120. ; Stop at the bottom of the hole for 1 s.
X1000. ; Position, drill hole 2, then return to initial level.
G80 G28 G91 X0 Z0 ; Return to the reference position return
M5 ; Cause the spindle to stop rotating.
Limitations
Axis switching
Boring
Q/R
Cancel
Tool offset
Examples

Leave a Reply

Your email address will not be published. Required fields are marked *