Fanuc Power Mate i-D/H Operator Manual

B–63174EN/03
1. GENERAL
GENERAL
3
1
GENERAL
This manual consists of the following parts:
I. GENERAL
Describes chapter organization, applicable models, related manuals,
and notes for reading this manual.
II to IV. PROGRAMMING
Describes each function: Format used to program functions in the NC
language, explanations, and restrictions.
V. OPERATION
Describes the manual operation and automatic operation of a machine,
procedures for inputting and outputting data, and procedures for
editing a program.
VI. MAINTENANCE
Describes procedures for replacing fuses and batteries.
APPENDIX
Lists tape codes, valid data ranges, and error codes.
Depending on the model, some functions described in this manual are
unusable. Refer to the Descriptions (B–63172EN) for details.
This manual does not describe parameters in detail. For details on
parameters mentioned in this manual, refer to the Parameter Manual
(B–63180EN).
This manual describes all optional functions. Look up the options
incorporated into your system in the manual written by the machine tool
builder.
The models covered by this manual, and their abbreviations are:
Product name Abbreviations
FANUC
Power Mate i–MODEL D
Power Mate i–D
Power Mate
i–D/D2
Power Mate
FANUC
Power Mate i–MODEL D
(at 2–path control)
Power Mate i–D2
FANUC
Power Mate i–MODEL H
Power Mate i–H
This manual uses the following symbols:
P
I _
:
Indicates a combination of axes such as X__ Y__ Z
(used in PROGRAMMING.).
:
Indicates the end of a block. It actually corresponds to
the ISO code LF or EIA code CR.
;
About this manual
Applicable models
Special symbols

Leave a Reply

Your email address will not be published. Required fields are marked *