Fanuc Power Mate i-D/H Operator Manual

2. FUNCTION TO SIMPLIFY
PROGRAMMING
PROGRAMMING
(For the Power Mate i–D/D2)
B–63174EN/03
196
This cycle is used to bore a hole.
G85
G85 X_ Z_ R_ F_ ;
X_ : Hole position data
Z_ : The distance from point R to the bottom of the hole
R_ : The distance from the initial level to point R level
F_ : Cutting feed rate
Point R
Initial level
Point Z
After positioning along the X– axis, rapid traverse is performed to point
R.
Drilling is performed from point R to point Z.
When point Z has been reached, cutting feed is performed to return to
point R.
Before specifying G85, use a miscellaneous function (M code) to rotate
the spindle.
When the G85 command and an M code are specified in the same block,
the M code is executed at the time of the first positioning operation. The
system then proceeds to the next drilling operation.
When a tool length offset (G43, G44, or G49) is specified in the canned
cycle, the offset is applied at the time of positioning to point R.
2.1.8
Boring Cycle (G85)
Format
Explanations

Leave a Reply

Your email address will not be published. Required fields are marked *