Fanuc Power Mate i-D/H Operator Manual

2. FUNCTION TO SIMPLIFY
PROGRAMMING
PROGRAMMING
(For the Power Mate i–D/D2)
B–63174EN/03
200
This cycle performs accurate boring.
G87
G87 X_ Z_ R_ Q_ P_ F_ ;
X_ : Hole position data
Z_ : The distance from the bottom of the hole to point Z
R_ : The distance from the initial level to point R (the bottom of the
hole) level
Q_ : Tool shift amount
P_ : Dwell time
F_ : Cutting feed rate
q
OSS
OSS
P
Point R
Point Z
Spindle CW
Spindle CW
Spindle orientation
Tool
Shift amount q
WARNING
Q (shift at the bottom of a hole) is a modal value retained in
canned cycles. It must be specified carefully because it is
also used as the depth of cut for G73 and G83.
2.1.10
Boring Cycle,
Back Boring Cycle
(G87)
Format

Leave a Reply

Your email address will not be published. Required fields are marked *